Skip to content

CCIE23050.com CCIE Network blog HTTP://1806971003

CCIE23050.com

  • Home
  • About Me
  • Contact Me

ping with tos – dscp

Posted on November 1, 2016 by admin

dscp 1 (000001) = tos (00000100) = tos decimal 4

Router(config)#access-list 105 deny ip any any dscp 1
Router(config)#access-list 105 permit ip any any
Router(config)#interface ethernet 0/1
Router(config-if)#ip access-group 105 out
Router#show access-list 105

Rack9SW2#ping 200.0.12.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 200.0.12.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 56/58/60 ms
Rack9SW2#ping
Protocol [ip]:
Target IP address: 200.0.12.2
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]: y
Source address or interface: Vlan118
Type of service [0]: 4
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 200.0.12.2, timeout is 2 seconds:
Packet sent with a source address of 192.168.118.8
U.U.U
Success rate is 0 percent (0/5)
Rack9SW2#

Posted in Cisco, IPTagged IP

Post navigation

ASA capture tips.
ASA EZVPN

Follow Me

  • YouTube
  • LinkedIn

Location

  • 10809 Executive Center Dr, Little Rock, AR 72211
Proudly powered by WordPress | Theme: micro, developed by DevriX.